Manually Register Add-in

If you receive one of the following message after installing Versa Note, the add-in must be registered manually.

To manually register the add-in:

1. Run the Command Prompt as administrator

2. Enter the following command:

"%Windir%\Microsoft.NET\Framework64\v4.0.30319\regasm" /codebase "%programfiles%\CAD Innovations\Versa Note\Versa Note.dll" 

3. Open SolidWorks and confirm that the Versa Note toolbar has loaded.

If you don’t see the Versa Note toolbar, check that the add-in is enabled and that it is set to start automatically when SolidWorks loads by checking both checkboxes beside Versa Note in the SolidWorks Tools -> Add-ins dialog, then press ‘OK’

If Versa Note is still won’t load in SolidWorks, contact support@cadinnovations.ca for further assistance.